Mounting the rear axle support
NOTE:
Perform the steps on the left and right side.
Installing rear thrust arm
- Replace screws (2)
and (3)
.
Parts: Screws
- Position thrust arm (1) .
- Screw in the screws (2) and (3) .
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATION
| Rear axle carrier to body | ||
| M12 Replace screws. |
tightening torque | 108 Nm |
- Tighten down screws (2) .
TIGHTENING TORQUE SPECIFICATION
| Thrust arm on body | ||
| M10 Replace screws. |
Joining torque | 47 Nm |
| Angle of rotation | 45° | |
Install thrust arm
- Replace screws (1)
and (2)
.
Parts: Screws
- Position thrust arm (3) .
- Screw in the screws (1) and (2) .
- Tighten down screw (2) .
TIGHTENING TORQUE SPECIFICATION
| Rear axle carrier to body | ||
| M12 Replace screws. |
tightening torque | 108 Nm |
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Thrust arm on body | ||
| M10 Replace screws. |
Joining torque | 47 Nm |
| Angle of rotation | 45° | |
Follow-up work
- Refer to FASTENING THE WIRING HARNESS TO THE M SPORT DIFFERENTIAL .
- Refer to INSTALLING THE REINFORCEMENT STRUT ON THE LEFT AND RIGHT .
- Refer to ATTACHING THE BRAKE CALIPER ON THE LEFT AND RIGHT .
- Refer to INSTALLING LEFT AND RIGHT COIL SPRING .
- Refer to FASTENING THE REAR LEFT AND RIGHT SHOCK ABSORBER TO THE BODY .
- Refer to SECURING CABLE OF REAR LEFT AND RIGHT WHEEL SPEED SENSOR .
- Refer to FASTENING THE CABLE FOR THE RIDE HEIGHT SENSOR ON THE REAR AXLE SUPPORT .
- Refer to SECURING THE PROPELLER SHAFT ON THE REAR DIFFERENTIAL .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .