Removing the rear differential (without GHAS)

WARNING: Hot surfaces .
Risk of burning!

Perform all work only on components that have cooled down.

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly .
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .

NOTE: RISK OF DAMAGE
Damage to rear differential .
Failure to comply with the oil specifications can result in serious damage to the rear differential .

After completion of repair work, check the oil level in the rear differential.
Use only the approved final drive oil.

Preliminary work

Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
Refer to REMOVING THE LOADING EDGE TRIM .
Refer to REMOVING TRUNK COMPARTMENT LIGHT .
Refer to REMOVING THE UPPER LUGGAGE COMPARTMENT TRIM PANELS .
Refer to PARTIALLY REMOVING LEFT AND RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
Refer to REMOVING THE COVER FOR THE WATER CHANNEL LEFT AND RIGHT .
Refer to REMOVING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANEL .
Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
Refer to REMOVING THE TORSION STRUT ON THE REAR LEFT AND RIGHT .
Refer to IF INSTALLED: REMOVING THE REAR AXLE COVER .
Refer to REMOVING THE REAR DIFFUSER .
Refer to REMOVING REAR BUMPER TRIM .
Refer to REMOVING BOTH EXHAUST COVERS .
Refer to REMOVING REAR BUMPER PANEL .
Refer to REMOVING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
Refer to REMOVING EXHAUST SYSTEM .
Refer to REMOVING THE HEAT SHIELD AT THE REAR .
Refer to RELEASING THE PROP SHAFT FROM THE REAR DIFFERENTIAL .
Refer to RELEASING THE RIGHT AND LEFT OUTPUT SHAFTS FROM THE REAR DIFFERENTIAL .

NOTE: RISK OF DAMAGE
Damage to rear differential .
If the rear differential drops down, persons can be injured or the rear differential can be damaged .

Secure the rear differential using a luggage strap.

Attach the special tool 0 496 009 (33 5 200) to the special tool 0 490 133 (00 2 030) .
Support the rear differential (1) with the special tool 0 496 009 (33 5 200) .
Secure the rear differential (1) with the special tool 0 496 080 (33 5 206) on the special tool 0 496 009 (33 5 200) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen nut (1) on the rear axle support at rear.

Courtesy of BMW OF NORTH AMERICA, INC.
Pull the bolt (1) out of the rear axle support.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Loosen nut (1) .
Remove the ground strap (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1) rear axle support at front.

Courtesy of BMW OF NORTH AMERICA, INC.
Lower the rear differential (1) with the special tool 0 496 009 (33 5 200) .
Twist the rear differential (1) towards the right and in this process, pull out the right-hand output shaft (2) .
Pull the left output shaft (3) out.
Tie up the output shafts (2) and (3) .
Completely lower the rear differential (1) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.