Apply liquid sealing compound
NOTE:
TECHNICAL INFORMATION
The processing time of the liquid sealing compound can be at a maximum of 10 min.
Commissioning of the assembly is not possible until 25 minutes after the processing time.
Non-observance can lead to leaks in the assembly.
The processing time of the liquid sealing compound can be at a maximum of 10 min.
Commissioning of the assembly is not possible until 25 minutes after the processing time.
Non-observance can lead to leaks in the assembly.
- Position the liquid sealing compound (1)
on the special tool as depicted 2 469 803
.
Parts: Liquid sealing compound
SEALING COMPOUND SPECIFICATIONLoctite 5970 liquid sealing compound Processing time <10 minutes at room temperature 50 ml, Cartridge 83190404517 - Apply liquid sealing compound along the dashed line (1)
on the sealing surface on the housing of the rear differential.
The sealing bead must run along the inner edge.
Follow-up work
- Refer to INSTALLING THE HOUSING COVER .
- Refer to LIFT THE REAR DIFFERENTIAL (WITH GHAS) .
- Refer to CHECK/TOPPING UP OIL LEVEL IN THE REAR DIFFERENTIAL .
- Refer to SECURING THE PROPELLER SHAFT ON THE REAR DIFFERENTIAL .
- Refer to INSTALLING THE HEAT SHIELD AT THE REAR .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to IF INSTALLED: INSTALLING THE REAR AXLE COVER .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to INSTALLING CENTER STIFFENING PLATE .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to INSTALLING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .