Install the VDP control unit
- Position the VDP control unit (2) on the holder.
- Tighten the nuts (arrows).
TIGHTENING TORQUES SPECIFICATION
| VDP control unit to holder | ||
|---|---|---|
| M6 | tightening torque | 6 Nm |
- Connect all the available connectors (1) to the VDP control unit.
Follow-up work
- Refer to INSTALLING THE REAR RIGHT SIDE TRIM PANEL .
- Refer to INSTALLING THE RIGHT SEAT BELT FINISHER STRIP .
- Refer to INSTALLING THE WINDOW RECESS FINISHER STRIP AT THE REAR RIGHT ON THE OUTSIDE .
- Refer to INSTALLING THE REAR SEAT .
- Refer to INSTALLING INSIDE RIGHT DOOR SILL COVER STRIP .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to PROGRAM/ENCODE THE VDP CONTROL UNIT .
- Refer to CARRYING OUT RIDE HEIGHT ADJUSTMENT .