Install catalytic converter

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

Replace the V-clip (1).
Parts: V-band clamp

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the seal (1).
Parts: Seal

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install catalytic converter.
Lock clamp (1).
Clamp (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten V-clip (1).

TIGHTENING TORQUE SPECIFICATIONS

Catalytic converter to exhaust turbocharger
V-band clamp Replace V-band clamp.	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace nuts (1).
Parts: Nuts
Tighten nuts (1).

TIGHTENING TORQUE SPECIFICATIONS

Catalytic converter to holder
M8 Nut Replace nut.	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the specified component(s) is/are installed.

Replace pressure hose (1)
Parts: Pressure hose
Insert the pressure hose (1) in the arrow direction all the way to the stop.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING EXHAUST SYSTEM .
Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
Refer to INSTALLING LAMBDA OXYGEN SENSOR .
Refer to INSTALLING INTAKE FILTER HOUSING .
Refer to INSTALLING THE RIGHT FRONT-END STRUT .
Refer to INSTALLING ACOUSTIC COVER .