Installing the vibration damper
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Coat sealing surface on the vibration damper (1) with clean engine oil.
- Position vibration damper (1) .
- Replace the bolts (arrows).
Parts: Screws
- Tighten the bolts (arrows) on the vibration damper (1)
.
TIGHTENING TORQUES SPECIFICATION
| Vibration damper with belt pulley to crankshaft | ||
| M10 Replace screws. |
1. Joining torque | 40 Nm |
| 2. Angle of rotation | 120° | |
- Clip the cover (1)
in at the vibration damper.
- Loosen screw (2) .
- Push the counter support with the screw (2) down opposite the arrow direction until the teeth (3) no longer mesh with the gearing of the flywheel (4) .
- Unscrew the screw (1) and remove the special tool 0 496 595 (11 6 130) .
Follow-up work
- Refer to INSTALLING STARTER MOTOR .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING RESONATOR .
- Refer to ACTIVATING ELECTRICAL SYSTEM .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to CHECKING ENGINE OIL LEVEL .