Install charge air line
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the sealing ring (1) on the throttle valve.
Parts: Sealing ring
- Check the sealing ring (1) on the charge air line for damage and replace if necessary.
Replacing the damaged seal
NOTE:
TECHNICAL INFORMATION
Use of sharp or pointy tools for installation or removal is prohibited.
Use of sharp or pointy tools for installation or removal is prohibited.
- Remove damaged seal.
- Clean the gasket groove (1) with a dry cloth.
The gasket groove (1) must be clean.
- Replace gasket.
Parts: Seal
- Install the seal dry without lubricant or mounting agent.NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position. - Thread in seal and install.
- Make sure that the seal is installed correctly in the gasket groove (1).
- Make sure that the sealing lip (2) is directed to the inside as shown.
- Insert and install charge air line (5).
- Lock the clamp (4) on the exhaust turbocharger.
Clamp (4) must engage audibly.
- Tighten screws (arrows).TIGHTENING TORQUE SPECIFICATIONS
Charge air line to throttle body M6 Tightening torque 8 Nm - Connect and lock connector (3) on the charge-air temperature sensor.
- Connect and lock connector (1) on the boost pressure sensor.
All connectors must audibly engage.
- Secure clamps (2).
Follow-up work
- Refer to INSTALLING RESONATOR .
- Refer to INSTALLING ACOUSTIC COVER .