Installing the support for the rear bumper cover
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
TIGHTENING TORQUES SPECIFICATION
| Support on impact plate | ||
|---|---|---|
| hexagon nut M12 | Tightening torque | 108 Nm |
- If installed:
- Position the rear muffler with holder (2) on the left and right on the support for the rear bumper cover.
- Replace nut (1).
Parts: Nut
- Tighten the nuts (1) on the left and right.
TIGHTENING TORQUES SPECIFICATION
| Rear silencer on support | ||
|---|---|---|
| M8 hexagon nut | Tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING THE BRACE FOR THE REAR BUMPER .
- Refer to INSTALLING REAR BUMPER PANEL .
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .