Install lock for rear seat backrest

• Position lock for the backrest covering (2) correctly.
  NOTE: Carefully open up backrest cover for adaptation of the lock of the backrest covering, so that the correction installation position can be determined.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Lock for rear seat backrest to vehicle body
  Screw	tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position Bowden cable (1) correctly in the lock for the backrest covering (2) and mount it carefully.
• Correctly position and clip in the Bowden cable bracket (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE PANEL OF THE LUGGAGE COMPARTMENT PARTITION WALL .
• Refer to INSTALLING THE TOP PARTITION WALL TRIM PANEL .
• Refer to INSTALLING REAR HEAD RESTRAINT .
• Refer to INSTALLING LEFT AND RIGHT REAR SIDE TRIM PANEL .
• Refer to INSTALLING THE LEFT AND RIGHT SEATBELT FINISHER STRIP .
• Refer to INSTALLING THE REAR SEAT .
• Refer to INSTALLING THE WINDOW CHANNEL STRIP AT REAR OUTER LEFT AND RIGHT .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .