Installing the guide for rear bumper cover
- Position the guide for the rear bumper cover.
- Tighten nuts (3) .
TIGHTENING TORQUES SPECIFICATION
| Guide for rear bumper at center on body | ||
|---|---|---|
| Nut and washer assembly with paint scrape groove | tightening torque | 5 Nm |
- Tighten down screw (2) .
TIGHTENING TORQUES SPECIFICATION
| Diffuser to rear bumper | ||
|---|---|---|
| Plastic hexagon screw | Tightening torque | 3 Nm |
- Clip in the wiring harness with the clip (1) .
Follow-up work
- Refer to IF INSTALLED: INSTALLING LANE CHANGE WARNING SENSOR .
- Refer to INSTALLING REAR PANEL .
- Refer to PARTIALLY INSTALLING THE REAR LEFT AND RIGHT WHEEL ARCH COVERS .
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING BOTH SIDE REAR TRIM STRIPS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING BOTH LEDS IN THE CARGO AREA .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .