Installing LED fan

• Feed in the guide from the LED fan (1) into the intake (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach and lock the connector (2) from the LED fan (1).

  Ensure correct cable routing in the headlight (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the seal (1) of the cover (2) for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cover flap (2) on the headlight.
• Tighten down screws (1),
  TIGHTENING TORQUES SPECIFICATION
  
  

  Cover cap to headlight
  Screw	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING HEADLIGHT .
• Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
• Refer to INSTALLING FRONT BUMPER COVER .
• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH COVERS .
• Refer to INSTALLING CENTER RADIATOR GRILLE .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to ADJUSTING HEADLIGHTS .