Installing the housing cover
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details
.
- Position the housing cover on the rear differential.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Lid to rear axle differential | ||
| M12 | tightening torque | 140 Nm |
| M10 | tightening torque | 90 Nm |
Follow-up work
- Refer to LIFTING THE REAR DIFFERENTIAL .
- Refer to CHECK/TOPPING UP OIL LEVEL IN THE REAR DIFFERENTIAL .
- Refer to FASTENING THE WIRING HARNESS TO THE M SPORT DIFFERENTIAL .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .