Installing the trim panel for the rear shelf

• Install trim panel (2) and guide in seat belts (3).
• Clip in the wiring harness with all the holders on trim panel (2) for the rear shelf.
• Connect all connectors and lock.
• Feed the trim panel (2) into the guides and position it correctly.
• Secure expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the seat belt finisher strip (2).
• Clip in the cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the rear seat belt end fitting (2) into the body.
• Replace the screw (1).

  Part  : Screw

• Tighten down screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATION
  
  

  End lining to body
  M10 Replace screw.	Tightening torque	42 Nm

Follow-up work 

• Refer to INSTALLING LEFT AND RIGHT REAR SIDE TRIM PANEL .
• Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
• Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .