Install left and right rear side trim panel

NOTE: Description is for left component only. Procedure on the right side is identical.

Install rear trim panel

Check clamps (1) for damage; replace if necessary.
Check the clips (2) for damage and replace where required.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect and lock all the connectors at the rear side trim panel (1) of the wiring harness and disconnect it.
Insert upper seat belt (5).
Position the rear side trim panel (1) and clip at the clamps (4).
Clip in the rear side trim panel (1) at the clips (3).
Clip in the rear side trim panel (1) at the clamps (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Clip in the cover (2) of the strap fitting (3) to the strap fitting (3).
Slide the sleeve (1) in the cover (2) of the seat belt end fitting (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the seat belt end fitting correctly.
Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATION

End lining to body
M10	Tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.