Install reinforcement strut
- Position the reinforcement strut (2) .
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATION
Reinforcement strut on cross connection and bumper bracket Hexagon screw M8 tightening torque 28 Nm
Follow-up work
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .