Installing the Y-cable
- Position the Y-line (3) as shown.
- Mount the wiring harness mounting (2) .
- Close the plug connection (1) .
Installing the busbar
- Install the busbar (3) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Busbar to housing | ||
|---|---|---|
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
- Tighten the screws (2) .
TIGHTENING TORQUE SPECIFICATION
| Busbar to housing | ||
|---|---|---|
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
- Install the shield plate (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Shield plate to housing | ||
|---|---|---|
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
- Close the plug connection (1) .
- Tighten the screws (2) .
TIGHTENING TORQUE SPECIFICATION
| Y-cable at housing | ||
|---|---|---|
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
Follow-up work
- Refer to CLEANING THE SEALING SURFACES (INSTALLATION OF THE REMOVED COVER OF THE EME) .
- Refer to INSTALLING THE REMOVED EME .
- Refer to CLEANING SEALING SURFACES .
- Refer to INSTALLING THE LID OF ELECTRICAL MACHINE ELECTRONICS .
- Refer to CHECKING THE TIGHTNESS OF THE COOLANT CIRCUIT OF THE ELECTRIC DRIVE UNIT .
- Refer to INSTALLING THE COOLANT LINES .
- Refer to EXECUTING FUNCTIONAL CHECKING BEFORE RE-INSTALLATION .
- Refer to REMOVING THE PRESSURE COMPENSATION ELEMENT FROM EME LID .
- Refer to PERFORM EOS TEST .
- Refer to STICKING THE PRESSURE COMPENSATION ELEMENT ON THE EME LID .
- Refer to REMOVING THE ELECTRICAL DRIVE UNIT FROM THE ASSEMBLY JIG .
- Refer to INSTALLING FRONT SOUND INSULATION .
- Refer to INSTALLING THE SUPPORT FOR ELECTRIC COOLANT PUMP .
- Refer to INSTALLING THE ELECTRIC DRIVE UNIT IN THE FRONT SUBFRAME .
- Refer to REMOVING THE MOBILE LIFTING TABLE .
- Refer to FASTENING THE RIDE HEIGHT SENSOR ON THE BOTTOM WISHBONE .
- Refer to SECURING THE TIE ROD ON THE LEFT AND RIGHT OF THE SWIVEL BEARING .
- Refer to INSTALLING COVERS AT FRONT BOTTOM ON LEFT AN RIGHT SIDES .
- Refer to PARTIALLY INSTALLING THE AIR DUCT FOR THE BRAKE ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to DELETE FAULT MEMORY .
- Refer to CALIBRATING AND TEACHING IN THE ROTOR POSITION SENSOR .