Installing the high-pressure line between the high-pressure pump and the high-pressure rail

• Guide the special tool 2 413 106 out and remove.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Thread in and install the high pressure line (2).
• Tighten union nut (1) hand tight.
• Tighten union nut (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  High pressure line between high pressure pump and rail
  M14	Tightening torque	33 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING ALL IGNITION COILS .
• Refer to WHEN WORKING ON THE LAST CYLINDER: MOUNTING THE SERVICE OPENING IN THE SOUND INSULATION ON TOP OF THE ENGINE .
• Refer to INSTALLING THE CYLINDER HEAD COVER ACOUSTIC COVER .
• Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
• Refer to INSTALLING ACOUSTIC COVER .