Remove right charge air cooler

WARNING: Hot surfaces.
Risk of burning!

Perform all work only on components that have cooled down.

WARNING: Hot fluids.
Risk of scalding!

Conduct all work in the vehicle wearing appropriate personal protective equipment only.

NOTE: TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.

NOTE: TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

Preliminary work

Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
Refer to REMOVING THE FRONT HOOD SEAL .
Refer to REMOVING THE CENTER ENGINE COMPARTMENT COVER .
Refer to RELEASING LEFT FRONT-END STRUT .
Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
Refer to RELEASING THE RIGHT FRONT-END STRUT .
Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
Refer to REMOVING UPPER CROSS CONNECTION .
Refer to REMOVING THE REAR TOP CROSS CONNECTION .
Refer to REMOVING FAN COWL WITH ELECTRIC MOTOR .
Refer to REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
Refer to DRAINING THE COOLANT FROM THE COOLANT PUMPS .
Refer to REMOVING OIL FILLER NECK .

Unlock the retaining clips (1) with a suitable screwdriver.
Detach the coolant lines (2) and set aside.
Unlock plug connection (3) and disconnect.

Courtesy of BMW OF NORTH AMERICA, INC.
Thread the hose (1) out of the holder on the charge air cooler (4).
Loosen hose clamp (3).
Pull the hose (2) off the stud of the charge air cooler.

Courtesy of BMW OF NORTH AMERICA, INC.
Thread the hose (1) out of the holder on the charge air cooler (4).
Loosen hose clamp (3).
Pull the hose (2) off the stud of the charge air cooler.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen hose clamp (1).
Loosen hose clamp (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the wiring harness mounting (1).
Loosen screw (2).
Feed out the holder (3) downwards from the groove (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Carefully unlock and disconnect the line (1).
Put the line to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock retaining clip (1) with a suitable screwdriver.
Remove the coolant line (2) and lay it to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Carefully unlock and disconnect the line (1).
Unlock plug connection (2) and disconnect.
Put the line to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock the holder with a suitable screwdriver at the lug (1) and remove it upward from the guide.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the line (1) from the holders (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1).
Unlock plug connection (2) and disconnect.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).
Removing connecting plate (2) between charge air coolers.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the hose clamps (1) on the charge air cooler (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed the charge air cooler (1) out toward the top and remove.

Courtesy of BMW OF NORTH AMERICA, INC.