Removing fan cowl with electric motor
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
Preliminary work
- Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
- Refer to REMOVING THE FRONT HOOD SEAL .
- Refer to REMOVING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to RELEASING LEFT FRONT-END STRUT .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to RELEASING THE RIGHT FRONT-END STRUT .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Loosen screw (1).
- Unlock plug connection (2) and disconnect.
- Unclip and feed out wiring harness mounting (1).
- Loosen screw (1).
- Only for F91, F92, F93:
Remove screws (arrows).
Feed out and remove the front underbody protection (1).
- F90 only:
Release all bolts (arrows).
- Push the front underbody protection (1) to the front slightly and guide out under the thrust field (2).
- Unclip the hose support (2) from the fan cowl (1).
- Guide out the fan cowl (1) upwards at the coolant hoses.
For follow-up work on the engine, install guard for cooler fins:
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
- Protect working area.
- Handle tools and components carefully.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Install guard (1).
NOTE:
Packaging made from corrugated cardboard with a thickness of at least 3 mm can be used as a guard (cut to the required size as required).