Installing the catalytic converter near engine, bottom at bank 2
WARNING:
Hot exhaust system.
Risk of burning!
Risk of burning!
- Any work must exclusively be carried out with an exhaust system that has cooled down.
- Replace gasket (1)
.
Parts: Seal
- Position the catalytic converter at the bottom of cylinder bank 2 (2) .
- Replace nuts (1)
.
Parts: Nuts
- Tighten nuts (1) .
TIGHTENING TORQUES SPECIFICATION
| Firewall catalytic converter to catalytic converter near engine | ||
|---|---|---|
| Nut M8 Replace nuts. |
Tightening torque | 17 Nm |
| Tightening torque | 28 Nm | |
Follow-up work
- Refer to CONNECTING THE EXHAUST SYSTEM .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to REMOVING UNDERBODY PROTECTION AT SIDE RIGHT AND LEFT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .