Fit the roof lining
- Check the clips (1)
on the headlining (2)
for damage and replace, if necessary.
- Insert the headlining (1) with a support person through the cutout of the windshield.
- Position the headlining (1)
with the aid of a support person.
- Clip in the headlining (2)
using the clips (1)
.
- Clip in the headlining (1) using the clips (2) .
Check
- Check clips (1) on the trim (2) for damage and replace, if necessary.
- Check the detent (3) on the trim (2) for damage.
Result
» Detent is damaged.
Measure
- Replace cover of the auxiliary brake light (2) .
- Fit the cover of the auxiliary brake light (1) from the bottom.
- Clip in the cover of the auxiliary brake light (1) with the clips (3) and the detent (2) .
NOTE:
Perform the steps on the right and left side.
- Fasten the expanding rivet (1) on the headlining (2) .
Follow-up work
- Refer to INSTALLING WINDSHIELD. .
- Refer to INSTALLING THE RAIN-LIGHT-SOLAR-CONDENSATION SENSOR (PARTIALLY REMOVED) .
- Refer to INSTALLING THE KAFAS CAMERA .
- Refer to INSTALLING INTERIOR REARVIEW MIRROR .
- Refer to ATTACHING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING THE GRAB HANDLE AT THE REAR LEFT AND RIGHT .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT VANITY MIRROR LIGHT .
- Refer to INSTALLING BOTH SUN VISORS AND COUNTER SUPPORTS .
- Refer to INSTALLING THE LEFT AND RIGHT HANDS-FREE MICROPHONE .
- Refer to INSTALLING THE C-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT SEAT BELT FINISHER STRIP .
- Refer to INSTALLING BOTH BACKREST SIDE SECTIONS .
- Refer to PARTIALLY INSTALLING BOTH B-PILLAR TRIM PANELS AT TOP .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to CALIBRATE KAFAS CAMERA .