Installing guide for rear center bumper cover

• Feed in and correctly position the guide (2)  for the rear left center bumper cover.
• Tighten nuts (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATION
  
  

  Guide for rear bumper panel
  Hexagon screw for thermoplastic	tightening torque	2 Nm
  Nut	tightening torque	4.6 Nm
  Screw TS6x20	tightening torque	2.6 Nm

• Tighten screws (1)  on the left and right.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATION
  
  

  Guide for rear bumper panel
  Hexagon screw for thermoplastic	tightening torque	2 Nm
  Nut	tightening torque	4.6 Nm
  Screw TS6x20	tightening torque	2.6 Nm

Follow-up work 

• Refer to INSTALLING REAR BUMPER PANEL .
• Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE TRUNK COMPARTMENT LIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .