Removing speaker and bracket

NOTE: Description is for left component only. Procedure on the right side is identical.

Preliminary work

Refer to REMOVING THE STORAGE NET .
Refer to REMOVING THE TRIM PANEL FOR THE TOP ROLLOVER PROTECTION .
Refer to REMOVING THE SEAT BELT FINISHER STRIP AT THE LEFT AND RIGHT .
Refer to REMOVING THE TRIM PANEL FOR THE REAR LEFT AND RIGHT BODY PILLAR .
Refer to REMOVING SIDE TRIM PANEL, REAR LEFT AND RIGHT .
Refer to REMOVING THE REAR CENTER CONSOLE TRIM .
Refer to RELEASING THE INNER PANEL FOR THE LUGGAGE COMPARTMENT PARTITION WALL .

NOTE: Description is for left component only. Procedure on the right side is identical.

Loosen screws (1) .
Pull out the speaker holder (2) slightly.
Unlock and disconnect the present plug connections and unclip the cable bracket.
Guide out the speaker holder (2) upwards and remove.

Courtesy of BMW OF NORTH AMERICA, INC.