33 55 000 Removing and installing/replacing rear anti-roll bar

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .
Lower REAR AXLE SUPPORT .

NOTE: To simplify the graphic, anti-roll bar removal is shown on the removed rear axle.

Release screws (1).

Tightening torque 33 55 1AZ .

Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .

Turn anti-roll bar (2) and remove from the side.

Fig 1: Identifying Anti-Roll Bar And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check both rubber mounts for damage and replace if necessary.

Keep retaining bracket, rubber mount and stabilizer clean and free from oil and grease.