33 55 021 Replacing both rubber mounts for anti-roll bar mounting
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Remove REAR WHEELS .
Release screws (1).
Tightening torque, 33 55 1AZ .
Pull off retaining bracket (2), open rubber mount (3) at slot and remove.
Installation note:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean rear anti-roll bar on both sides.
Position rubber mount on rear anti-roll bar.
Mount retaining bracket (2) on rubber mount (3).
Push rubber mount with retaining bracket on rear anti-roll bar to installation position and screw tight.