Replacing rear left or right support bearing for shock absorber

Special tools required: 

• 2 360 213

Installation note: 

1. All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
2. Retaining elements on chassis and suspension and steering parts must be replaced.

Necessary preliminary tasks: 

• Remove REAR SHOCK ABSORBER .

Removal: 

Remove protective cap (1) and sealing washer (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) with special tool 2 360 213, reversible ratchet with extension (3) and socket SW10.

Remove spring strut mounting (2).

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber! 

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Position support bearing (2).

Part  : Replace nut (1).

Tighten down nut (1) with special tool 2 360 213, reversible ratchet with extension (3), socket SW10 and torque wrench with ring spanner attachment SW21.

Tightening torque 33 52 2AZ .

Impact screwdrivers are prohibited!

Courtesy of BMW OF NORTH AMERICA, INC.

Risk of damage inside the shock absorber! 

Check sealing washer (2) for damage.

Part  : Replace sealing washer (2) if necessary.

Place sealing washer (2) in position.

Mount protective cap (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install REAR SHOCK ABSORBER .