Removing and installing/replacing temperature sensor
WARNING:
Risk of burning if exhaust system is touched!
Danger of poisoning if oil is ingested/absorbed through the skin!
Danger of injury if oil comes into contact with eyes and skin!
Danger of poisoning if oil is ingested/absorbed through the skin!
Danger of injury if oil comes into contact with eyes and skin!
Removal:
IMPORTANT:
Have new part ready to avoid unnecessary escape of differential oil.
Disconnect plug connection (1).
Loosen temperature sensor (2) from oil sump (3).
Installation:
Screw the temperature sensor (2) into the oil sump (3).
Tightening torque 33 11 4AZ .
Connect connector (1) to temperature sensor (2).
Clean rear differential.
Required follow-up work:
- Check OIL LEVEL , correct if required.