Installing the lumbar support with pump
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Correctly position and fasten the lumbar support (1)
in the marked areas on the spring wire (2)
.
- Feed in the pump (3) and position it correctly.
- Fasten the cable tie (1) .
- Connect connectors (2)
and lock.
- Correctly position the valve unit (2) and fasten it on the spring wire.
- Clip the pneumatic lines into the brackets in the marked areas.
- Connect connectors (1)
and lock.
Follow-up work
- Refer to INSTALLING THE BACKREST COVER WITH THE CUSHION FOR THE FRONT SEAT .
- Refer to INSTALLING SIDE AIRBAG IN FRONT SEAT .
- Refer to INSTALLING THE REAR PANEL ON THE FRONT SEAT BACKREST .
- Refer to INSTALLING THE INNER COVER ON THE FRONT SEAT .
- Refer to INSTALLING THE OUTER COVER ON THE ELECTRICAL FRONT SEAT .
- Refer to INSTALLING GUIDE SLEEVE FOR FRONT HEAD RESTRAINT .
- Refer to INSTALLING THE HEAD RESTRAINT IN FRONT .
- Refer to INSTALLING FRONT SEAT .
- Refer to INSTALLING THE FRONT STRAP FITTING .