Install front seat
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
After continuing work on the front seat: Disconnecting the front seat from the wiring harness of the vehicle and removing it from the universal seat mount
NOTE:
TECHNICAL INFORMATION
Only use the following steps if the front seat has to be adjusted electrically.
Only use the following steps if the front seat has to be adjusted electrically.
- Disconnect the special tool 0 496 519 (61 4 150)
from the wiring harness of the vehicle and from the removed front seat.CAUTION: Heavy component .
Heavy components can lead to injury or damage .- Remove and install heavy components with the aid of another person/other persons.
- Remove front seat from the special tool 2 473 334
.NOTE: RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .- Protect working area.
- Handle tools and components carefully.
- Cover the door sill using protective covers.NOTE: RISK OF DAMAGE
Heavy component .
Heavy components can lead to injury or damage .- Remove and install heavy components with the aid of another person/other persons.
- With the assistance of another, lift the front seat into the vehicle and position.
- Place front seat to the rear and connect the connector (1).
- Adjust the front seat to the rear.
- Replace screws (1). Parts: Screws
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Seat to body Cheese head screw with collar Replace screw. Tightening torque 42 Nm - Adjust front seat forward.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Seat to body Cheese head screw with collar Replace screw. Tightening torque 42 Nm Connecting all battery ground leads
- See CONNECTING THE BATTERY EARTH LEAD
.
Follow-up work
- Refer to INSTALLING THE FRONT STRAP FITTING .