Install the rubber mount for the transmission bearing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Install transmission mount.
- Replace the screw (1).
Parts: Screw
- Tighten the bolt (1) in the wheel arch.
TIGHTENING TORQUE SPECIFICATIONS
| Transmission mount on exterior side member | ||
|---|---|---|
| M10 Replace screw |
Tightening torque | 28 Nm |
- Replace screws (1).
Parts: Screws
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Transmission mount to side member, inner | ||
|---|---|---|
| M10 Replace screws |
Tightening torque | 56 Nm |
NOTE:
TECHNICAL INFORMATION
With a new transmission, no thread is available.
The thread is cut into the positioning holes of the transmission with the thread rolling screws of the transmission mount.
With a new transmission, no thread is available.
The thread is cut into the positioning holes of the transmission with the thread rolling screws of the transmission mount.
- Replace screws (2).
Parts: Screws
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Transmission mount to transmission | ||
|---|---|---|
| M10 Replace screws. |
Joining torque (transmission without thread) | 56 Nm |
| Angle of rotation | 90° | |
| M10 Replace screws. |
Joining torque (transmission with thread) | 40 Nm |
| Angle of rotation | 90° | |
- Install the battery tray (5).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Battery carrier to body | ||
|---|---|---|
| Tightening torque | 19 Nm | |
- Install the wiring harness (4) on the battery tray (5).
- Insert the control unit (3) into the bracket.
- Insert partition wall (2) for the battery into the bracket.
Follow-up work
- Refer to INSTALLING THE FRONT WHEEL ARCH COVER .
- Refer to MOUNTING THE WHEEL .
- Refer to INSTALLING THE FRONT WHEEL ARCH TRIM .
- Refer to REMOVING THE ENGINE BRIDGE .
- Refer to INSTALLING BATTERY CARRIER .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE SYSTEM BATTERY .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .