Remove the engine bridge
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
- Detach the spindle screw (1) from the engine bridge.
- Unscrew the leg screws (2) and (3).
- Guide the engine bridge out of the vehicle with the help of another person and remove.
- Unscrew the bolts (1) of the special tool 2 459 012 .
- Feed out the special tool 2 459 012
at the cylinder head and remove.
- Tighten the screw (1) of the hood catch.TIGHTENING TORQUE SPECIFICATIONS
Cross connection on support for cross connection M6x20 Tightening torque 12 Nm - Tighten the screw (1) of the hood catch.
TIGHTENING TORQUE SPECIFICATIONS
| Cross connection on support for cross connection | ||
| M6x20 | Tightening torque | 12 Nm |
Follow-up work
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .