Installing hydraulic valve
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in hydraulic valve (3) and install.
- Tighten down screw (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Hydraulic valve to crankcase | ||
| M6x18 | tightening torque | 8 Nm |
- Connect and lock the connector (1) .
- Make sure the connector (1) engages audibly.
- Guide in the wiring harness section (2) and install.
- Connect connector (1) to oil pressure switch and lock.
- Make sure the connector (1) engages audibly.
Follow-up work
- Refer to INSTALLING HEAT MANAGEMENT MODULE .
- Refer to CONNECTING THE COOLANT LINE .
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to INSTALLING FAN COWL WITH ELECTRIC FAN .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to FILLING THE COOLANT CIRCUIT WITH THE VACUUM FILLING EQUIPMENT .
- Refer to CONNECTING THE BATTERY EARTH LEAD .
- Refer to AIR BLEEDING THE COOLANT CIRCUIT .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .