Installing the wastegate valve controller for the left exhaust turbocharger
- Position the wastegate valve controller.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Wastegate valve controller to exhaust turbocharger | ||
|---|---|---|
| M4x16 | Tightening torque | 2 Nm |
The connector must engage audibly.
Follow-up work
- Refer to INSTALLING LEFT CLEAN AIR PIPE .
- Refer to MOUNTING THE ALTERNATOR 2 .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to CHECKING THE FUNCTION OF THE WASTEGATE VALVE CONTROLLER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING THE HEATER RETURNING HOSE ON THE COOLANT PUMP .
- Refer to MOUNTING AIR CONDITIONING COMPRESSOR .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR 2 AND THE AIR CONDITIONING COMPRESSOR .
- Refer to CHECKING THE DRIVE BELT FOR ALTERNATOR 2 .
- Refer to REMOVING THE PROTECTIVE PLATE AT THE RADIATOR .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING LEFT INTAKE PORT .
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to INSTALLING THE LEFT-HAND AIR DUCT .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FANFARE HORN, RIGHT .
- Refer to INSTALLING THE FANFARE ON THE LEFT SIDE .
- Refer to INSTALLING THE CENTER TOP CROSS CONNECTION .
- Refer to INSTALLING BOTH HEADLIGHTS .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE STEERING GEAR .
- Refer to INSTALLING THE UNIVERSAL JOINT AT THE BOTTOM OF THE STEERING SHAFT .
- Refer to ATTACHING THE UNIVERSAL JOINT TO STEERING GEAR .
- Refer to INSTALLING BOTH TIE ROD ENDS .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to FASTENING THE WIRING HARNESS OF THE ACTIVE STABILIZER .
- Install the front section of the front right wheel arch cover. Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT STIFFENING PLATE .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING CHARGE AIR PIPE ON LEFT .
- Refer to INSTALLING TOP CLEAN AIR PIPE ON LEFT .
- Refer to INSTALLING THE LEFT THROTTLE BODY .
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to CHECKING THE COOLANT LEVEL IN THE HIGH-TEMPERATURE COOLANT CIRCUIT AND TOPPING UP AS NEEDED .
- Refer to CHECKING THE AIRBAG FOR FUNCTION .
- Refer to DELETE FAULT MEMORY .
- Refer to ADJUSTING HEADLIGHTS .