Install the oil vacuum pump

Check 

• Check the correct position of the lining sleeves (1)  and whether or not they are damaged.

Result 

» Lining sleeves (1) are damaged or missing.

Measure

• Replace the lining sleeves (1).
• Replace sealing ring (1).

  Parts:  Sealing ring

• Insert oil vacuum pump (1) into the drive chain (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the oil vacuum pump (2) correctly on the fitting sleeves.
• Tighten the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to REFITTING ENGINE OIL PAN .
• Refer to TIGHTENING THE OIL DRAIN PLUG .
• Refer to INSTALLING STARTER MOTOR .
• Refer to RAISING FRONT AXLE SUPPORT .
• Refer to TOPPING UP THE ENGINE OIL .
• Refer to CHECKING ENGINE OIL LEVEL .