Installing oil pan (engine or transmission removed)

NOTE: TECHNICAL INFORMATION 
The sealing surfaces must be free of oil, grease and cleaning agents.

• Remove coarse seal residue from the sealing surface (1) and the sealing surface of the oil pan with the special tool 0 495 102 (11 4 470)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  The sealing surfaces must be free of oil, grease and cleaning agents.
• Remove small seal residue from the sealing surface (1) and the sealing surface of the engine block with the special tool 0 495 102 (11 4 470)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  The processing time of the liquid sealing compound can be at a maximum of 10 min.
  Commissioning of the assembly is not possible until 25 minutes after the processing time.
  Non-observance can lead to leaks in the assembly.
• Apply sealing compound along the line (1) on the inner edge.
  SEALING COMPOUND DESCRIPTION
  
  

  Loctite 5970 liquid sealing compound Processing time <10 minutes at room temperature

  50 ml, Cartridge

  83190404517

  Courtesy of BMW OF NORTH AMERICA, INC.

• Completely encircle the oil return orifice with sealing compound.
  TECHNICAL DATA SPECIFICATION
  
  

  Height of the sealing bead
  	2.0 mm... 2.5 mm

  NOTE: TECHNICAL INFORMATION 
  The special tool 11 8 780 is only required when the transmission is removed.
• Position the special tool 0 496 120 (11 8 780)  with the transmission bolts (1) so that the oil pan is exactly flush with engine block.
• If necessary, replace lining sleeves.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install oil sump (1) to top front.
• Hand-tighten all oil pan screws but do not tighten completely.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Transmission to oil pan (manual transmission and automatic transmission)
  M8 x 50	Tightening torque	19 Nm

• Attach cable in the marked area.
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Oil sump to crankcase
  M8 x 110	Tightening torque	24 Nm

• Tighten the screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Oil sump to crankcase
  M8 x 30	Tightening torque	24 Nm

• Tighten all bolts (marks).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Oil sump to crankcase
  M8 x 30	Tightening torque	24 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten all bolts (marks).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Oil sump to crankcase
  M8 x 30	Tightening torque	24 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten all bolts (marks).

TIGHTENING TORQUE SPECIFICATIONS

Oil sump to crankcase
M8 x 30	Tightening torque	24 Nm

Courtesy of BMW OF NORTH AMERICA, INC.