Installing starter motor
Prerequisite
Battery earth lead is disconnected.
- Mount the starter motor (2) .
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Starter mounting to engine M8x60 Tightening torque
19 Nm - Mount the positive battery cable on the starter motor.
- Tighten the nut and mount the cover (1)
.TIGHTENING TORQUE SPECIFICATIONS
Battery positive lead to starter Cap nut M8 Tightening torque
13.5 Nm - Mount the cable (terminal 50) on the starter motor and tighten the nut (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Terminal 50 to starter motor | |
| M6 hexagon nut | Tightening torque 7 Nm |
Follow-up work:
- Refer to INSTALLING THE SUPPORT FOR THE UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR
- Refer to CONNECTING THE BATTERY EARTH LEAD .
- Install right luggage compartment trim panel. Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES COUPE/CONVERTIBLE) or INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES GRAN COUPE SEDAN) .