11 00 670 Securing engine in installation position: Notes
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS
- Refer to REMOVING THE ACOUSTIC COVER
- Refer to UNINSTALLING COVER FOR THE DME CONTROL UNIT
- Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION MODULE (PDM)
- Refer to REMOVING THE DME CONTROL UNIT
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Remove the cover in the left engine compartment
- Remove the right cover in the engine compartment
- Remove the sound insulation on the bulkhead upper part at the center
Follow-up work
- Lower the engine and detach the engine bridge
- Install the sound insulation on the bulkhead upper part at the center
- Install the cover in the engine compartment on the left
- Install the cover in the engine compartment on the right
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to INSTALLING THE DME CONTROL UNIT
- Refer to CONNECTING THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT
- Refer to INSTALLING ACOUSTIC COVER
- Refer to CONNECTING ALL BATTERY GROUND LEADS
- Take hood out of the service position