12 51 240 Remove and install/replace Module 2, sensor system engine wiring: Notes
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER
- Remove the cover in the left engine compartment
- Remove the right cover in the engine compartment
- Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME
- Remove the sound insulation on the bulkhead upper part at the center
- Refer to REMOVING ACOUSTIC COVER AT REAR
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
- Refer to REMOVE CHARGE AIR LINE
- Refer to UNINSTALL COVER FOR THE DME CONTROL UNIT
- Refer to DISCONNECTING CONNECTOR FROM DME CONTROL UNIT AND FROM POWER DISTRIBUTION MODULE (PDM)
Follow-up work
- Refer to CONNECT THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
- Refer to INSTALL COVER FOR THE DME CONTROL UNIT
- Refer to INSTALL CHARGE AIR LINE
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Install the sound insulation on the bulkhead upper part at the center
- Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90° NOTE: Replace screws.
- Install the cover in the engine compartment on the left
- Install the cover in the engine compartment on the right
- Refer to INSTALL ACOUSTIC COVER