13 62 560 Removing and installing/replacing hot film air mass meter (B37, B38, B46, B47, B48)

WARNING: This page is about a different variant/trim than selected.

Removal:

Unlock connector (1) and pull off.

Unfasten screws (2).

Remove the hot film air mass meter (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install hot film air mass meter (3).

Tighten down screws (2).

Tightening torque 13 62 6AZ .

Attach connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Reset the adaptation values for the air mass system with the MINI diagnosis system.