13 62 531 Replace coolant temperature sensor (B38, B48)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Risk of scalding!
Only perform this repair work on an engine that has cooled down.
Only perform this repair work on an engine that has cooled down.
Recycling
Catch and dispose of escaping coolant.
Observe country-specific waste disposal regulations.
Necessary preliminary tasks:
- Remove INTAKE PLENUM .
Removal:
Unlock connector (1) and pull off.
Release and remove coolant temperature sensor (2).
Replace gasket.
Part: Gasket.
Installation:
Screw in and tighten coolant temperature sensor (2).
Tightening torque 13 62 5AZ .
Attach connector (1).
Connector (1) must engage audibly.
Required follow-up work:
- Install INTAKE PLENUM .
- Check coolant level, top up if necessary
- Check cooling system for leaks.