When replacing the module bracket on the front door: Remount components
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to REMOVING THE WINDOW CHANNEL STRIP ON THE FRONT DOOR .
- Refer to REMOVING THE MIRROR TRIANGLE COVER .
- Refer to REMOVING THE DECORATIVE STRIP FROM THE DOOR TRIM PANEL .
- Refer to REMOVING FRONT DOOR TRIM PANEL .
- Refer to REMOVING THE MODULE BRACKET FROM THE FRONT DOOR .
Removing airbag sensor from the front door
- Unlock plug connection (1) and disconnect.
- Unlock the detent (2).
- Turn airbag sensor (3) in the arrow direction and remove.
Removing flat motor for the front power windows
- Lift fleece (1) as shown.
- Unlock plug connection (2) and disconnect.
- Loosen screws (3).
- Remove the flat motor (4).
Removing mid-range speaker from the front door
- Disconnect plug connection (1).
- Loosen screws (2).
- Remove the mid-range speaker (3).
- Replace the module bracket on the front door.
Parts: Module bracket
Installing airbag sensor in the front door
- Correctly position the airbag sensor (1) and turn it in the direction of the arrow until the detent (2) engages.
- Connect connectors (3) and lock.
Installing flat motor for front power windows
- Correctly position the flat motor (4).
- Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Drive for power windows screw Tightening torque 3.5 Nm - Connect connectors (2) and lock.
- Fold the fleece (1) downwards.
Installing the mid-range speaker in the front door
- Correctly position the mid-range speaker (3).
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Loudspeaker to front door screw Tightening torque 1.9 Nm - Connect connector (1).
Follow-up work
- Refer to INSTALLING THE MODULE BRACKET ON THE FRONT DOOR .
- Refer to INSTALLING FRONT DOOR TRIM PANEL .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE DOOR TRIM PANEL .
- Refer to INSTALLING THE MIRROR TRIANGLE COVER .
- Refer to INSTALLING THE WEATHER STRIP ON THE FRONT DOOR .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .