Removing the right radial shaft seal on the differential
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to DISCONNECTING THE NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL AT FRONT AND REAR .
- Refer to REMOVING THE CROSS STRUT WITH THE TORSION STRUT .
- Refer to REMOVING EXHAUST SYSTEM .
- Refer to REMOVING FRONT HEAT SHIELD .
- Refer to REMOVING HEAT SHIELD AT REAR .
- Refer to REMOVING PROP SHAFT .
- Refer to REMOVING THE WHEEL .
- Refer to REMOVING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY REMOVING RIGHT OUTPUT SHAFT .
- Refer to REMOVING STARTER MOTOR .
- Refer to REMOVING THE INTERMEDIATE SHAFT WITH THE SUPPORT TUBE .
- Refer to REMOVING INTERMEDIATE SHAFT WITH SUPPORT TUBE .
- Refer to REMOVING HOLDER WITH RUBBER MOUNT .
- Refer to REMOVING TRANSFER BOX (VTG) .
- Screw the special tool 2 409 025 into the outer radial shaft seal.
- Turn the screw on the special tool 2 409 025 until the outer radial shaft seal is pulled out.
NOTE:
Inner radial shaft seal leaky: Exchange the transmission.