Adjusting selector lever (AISIN F22AW) (X2 sDrive 28i 2018-2023)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in tooth meshing noises be transmitted into the passenger compartment.
Necessary preliminary tasks:
- Move selector lever into "P" position.
- Refer to REMOVING INTAKE SILENCER HOUSING .
Removal:
Release screw (1).
The head piece for tolerance compensation must be easily moveable before installation.
Release ball socket (1) from ball stud.
Release the cable (2) from the support angle.
Position "P" of selector lever (1) is the rearmost locked position.
Installation:
Press in cable (2) into the support angle.
Ensure cable counter support audibly engages.
Press on ball socket (1) onto ball stud.
Tighten screw (1).
Tightening torque 24 51 1AZ .
Required follow-up work:
- Refer to INSTALLING INTAKE SILENCER HOUSING .