Remove the radial shaft seal for the left connection shaft
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to DISCONNECTING THE NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL AT FRONT AND REAR .
- Refer to REMOVING THE CROSS STRUT WITH THE TORSION STRUT .
- Refer to REMOVING EXHAUST SYSTEM .
- Refer to REMOVING FRONT HEAT SHIELD .
- Refer to REMOVING HEAT SHIELD AT REAR .
- Refer to REMOVING PROP SHAFT .
- Refer to REMOVING THE WHEEL .
- Refer to REMOVING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY REMOVING RIGHT OUTPUT SHAFT .
- Refer to REMOVING STARTER MOTOR .
- Refer to REMOVING THE INTERMEDIATE SHAFT WITH THE SUPPORT TUBE .
- Refer to REMOVING INTERMEDIATE SHAFT WITH SUPPORT TUBE .
- Refer to REMOVING HOLDER WITH RUBBER MOUNT .
- Refer to REMOVING TRANSFER BOX (VTG) .
NOTE:
TECHNICAL INFORMATION
Do not use a drill.
Shavings can damage the transmission and result in failure of the transmission.
Do not use a drill.
Shavings can damage the transmission and result in failure of the transmission.
- Drive a hole into the radial shaft seal (1) using a center punch.
- Screw the special tool 0 491 454 (23 0 490) into the radial shaft seal (1) .
- Drive out the radial shaft seal (1) with the impact weight (2) .