Installing The Support For The Left Cross Connection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Guide in and attach the support for the left cross connection (2).
- Attach the screws (1) and screw in a few revolutions.
- Set the support for the cross connection (1) according to the specified dimensions.
Dimension (a) = approximately 4 mm
- If the support for the cross connection (1) was only removed on one side of the vehicle, the dimension (a) of the non-removed side is to be used as the adjusting dimension.
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Support for cross connection support to deformation element M6x20 screw Tightening torque 11.8 Nm - Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Support for cross connection support to deformation element M6x20 screw Tightening torque 11.8 Nm - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Support for cross connection to wheel well M6x20 screw Tightening torque 12 Nm - Clip the housing for the coupling of the Bowden cables (1) into place.
Follow-up work
- Refer to INSTALL FRONT CROSS CONNECTION .
- Refer to INSTALL THE STRUT BRACE .
- Refer to FASTEN THE CHARGE AIR LINE TO THE INTAKE SYSTEM .
- Refer to INSTALLING INTAKE SILENCER HOUSING .