Installing The Headlamp Bracket On The Right
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position the headlamp bracket (3) .
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATIONS
Headlamp bracket to hood lock support Hexagon screw M6x20 Tightening torque I 8 Nm - Tighten nuts (1).TIGHTENING TORQUE SPECIFICATIONS
Headlamp bracket to hood lock support Nuts M6 Tightening torque 8 Nm - Clip the cable clip (1)
into the detents.
Follow-up work
- Refer to INSTALL RIGHT HEADLIGHT .
- Refer to INSTALL BUMPER COVER, FRONT .
- Refer to INSTALL TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALL FRONT LEFT AND RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT CENTRE BONNET SEAL .
- Refer to INSTALL BONNET SEAL ON LEFT AND RIGHT SIDES .