Install bumper cover, front

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Connect and lock the connector plug (1) at the front fog lamps
Set down and position the bumper trim at the front.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Bumper panel to headlamp
Thermoplastic multi-purpose bolt	Tightening torque	2.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Bumper panel to air duct
Screw M6	Tightening torque	4.6 Nm

NOTE: Description is for left component only. Procedure on the right side is identical.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Front bumper panel to fender
Screw TS5X35	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Front bumper panel to undershield
Thermoplastic hexagon screw	Tightening torque	2.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING TEMPERATURE SENSOR .
Refer to PARTIALLY INSTALLING FRONT LEFT AND RIGHT WHEEL ARCH COVER .
Refer to PARTIALLY INSTALLING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
Refer to INSTALLING THE FRONT CENTER HOOD SEAL .
Refer to INSTALLING HOOD SEAL ON LEFT AND RIGHT SIDES .