Install the rear trim seal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
- Remove adhesive residue on the rear trim and clean the adhesive area (2) with solvent cleaner R2.
- Replace the seal (1)
.
Parts: Seal
- Connect the seal (1) on the rear trim (3) .
- Pull the liner* off of the adhesive strip.
* The liner is the protective film on a new seal.
- Press the seal (1)
in the adhesive area (2)
onto the rear trim (3)
.
Follow-up work
- Refer to INSTALLING THE REAR TRIM .
- Refer to INSTALLING THE TAILGATE BUTTON .
- Refer to INSTALLING THE TAILGATE TRIM PANEL .
- Refer to MOUNTING BOTH TRIM PIECES FOR THE REAR WINDOW FRAME ON THE SIDE .
- Refer to INSTALLING THE TRIM FOR THE TOP REAR WINDOW FRAME .