Install brake caliper in the rear
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Fit and tighten brake hose (2) on brake caliper.TIGHTENING TORQUE SPECIFICATIONS
Brake hose to brake caliper, rear Tightening torque 24 Nm - Make sure that the brake hose (2) is not twisted and is not resting on the components attached to the body.
- Hook the brake hose (2) in the holders (1).
- Position and tighten the union screw (1), if necessary use the square end (2) for counter support.
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR BRAKE FLUID .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .