Disconnecting the bleeder unit for brake fluid
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Paint damage .
Mechanical or chemical action may lead to paint damage .
Paint damage .
Mechanical or chemical action may lead to paint damage .
- Cover up working area with specified covering material only.
- Switch off bleeder unit (1) and remove from brake fluid expansion tank.
- Check the brake fluid level; if necessary, adjust to maximum mark.
- Check the seal (1) of sealing cap for damage and replace it if necessary.
- Mount the sealing cap on the brake fluid expansion tank.
Installing front windshield panel cover
- Guide in and install the front fairing panel cover (2) in the rear fairing panel cover (3).
- Ensure the front fairing panel cover (2) is seated correctly.
- Secure expanding rivet (1).
Installing the rear hood seal
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Install the hood seal (1) and make sure it has a correct fit.
Follow-up work